The third guitar is a Warmoth that I built for this purpose. The goldfoil pickup actually gives a better acoustic tone than the piezo in my view. I've actually pulled the active electronics out of this guitar and replaced the magnetic pickup with a Supro goldfoil type. The EQ on the acoustic side was pretty good at making the piezo usable as an acoustic sound. This one was fun to play in a two amp setup with one being an acoustic amp. I've tried several different piezo setups on this and the best sounding was a Schatten Soundboard transducer. One is a Godin A6 Ultra that I found really cheap. ![]() ![]() The piezo sounded horrible on this guitar. One of them is now a fretless guitar that also has a 13-pin jack on it and is mainly used to do fretless synth stuff. I have 3 guitars with piezo/magnetic combos that run out in stereo. I think it can be amazing to have two simultaneous outputs (humbucker and piezo) that can be recorded and processed with different fx Anybody has already try it and can share experience? It's cheap and so easy to do, but adds so much value.I fall in love "on paper" with the PRS SE hollowbody II piezo. I ended up putting a piezo in all my guitars. It's so cheap to do that and if you use the method I described above (and don't care about the visible wire), there is absolutely no risk in it, as all you need to do is replacing the jack. I did that retrofitting and definitely did not regret it. I personally love to blend the piezo sound with my magnetic pickups. And if your guitar only got a neck humbucker, then it's definitely a no-brainer, as that 150$ piezo will add so much more tonal flexibility to the guitar than any effect I can think of. A piezo based tone match will still sound better, most of the time. If you got a neck single coil, you can get some good tone matches. ![]() Then I compared mine to a piezo equipped LP and noticed the dramatic difference. I heard this sound clip from a guy that had one of those piezo equipped parkers and couldn't believe how good it sounds. Piezos catch the acoustic sound of your electric guitar after all, so having a Piezo on hollowbody or semi-hollowbody guitars will yield totally different results than having a Piezo on an LP. Recommended!Ĭlick to expand.I don't think you can generalize that. In the end, I use the Axe FX II anyway, so why bother adding tone or volume to the piezo output? Instead, I control EQ and volume directly in the presets and have the full freedom to mix piezo and magnetic signal in the presets.Īll you need then is an Y cable (TRS to double TS) and two volume blocks at the beginning of the grid to seperate the left (magnetic) and right (piezo) channel. connect the magnetic pickups output wire to the tip and both the piezo and magnetic ground to the sleeve of the stereo jack ![]() pull the wires through the hole on the bridge pickup and then use the existing holes in the body to connect it to the stereo jack ring connector replace the 1/4" jack with a stereo jack wind a black rubber around the wires so that it looks better (since the guitar has a black body) filling a small hole into the ring of the bridge humbucker I didn't even add tone and volume controls to it. My experience with adding a piezo bridge to my guitar was, that for my needs a passive piezo system was totally sufficient (well, it doesn't really sound like a real acoustic guitar, but it's still a nice effect, especially when used in a band mix).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |